Matt48
Well-known member
Hi
picked up a spare engine lid ages ago, cheap and welded on a couple of new patches so not perfect but will do whilst I take off the current lid which is not original and maybe repair that one.
So here is the question the screws holding the hinge in place are rusted to buggery, has anyone successfully drilled them out? Or glued and an extension on so they can be un screwed, or hacksawed them off? Cannot see any videos on utube, someone must have done this, got new hinges if necessary and screws from jk. Need a new number plate light cover but might be able to rescue original.
Thanks for any ideas .
picked up a spare engine lid ages ago, cheap and welded on a couple of new patches so not perfect but will do whilst I take off the current lid which is not original and maybe repair that one.
So here is the question the screws holding the hinge in place are rusted to buggery, has anyone successfully drilled them out? Or glued and an extension on so they can be un screwed, or hacksawed them off? Cannot see any videos on utube, someone must have done this, got new hinges if necessary and screws from jk. Need a new number plate light cover but might be able to rescue original.
Thanks for any ideas .