Hi,
I'm about to cut out the back of my passenger seat metal bulkhead from my walkthrough early bay.
I've seen plenty of pictures of the conversion, but I've not found any details of the size of the plate required.
Does anybody have the dimensions of the plate?
Also, when cutting the bulkhead out, where is the best place to cut? Should I make the vertical cut along the B pillar from the passenger seat side or from the rear?
On the base section, Is the cut made above the lip of the seam of the two panels? If so, do you just hammer this seam flat & weld it onto the seat base for further strength?
Are the old seat runners easier to grind off or should I drill the spot welds?
Any recommendations on swivel seat bases?
All suggestions appreciated!
I'm about to cut out the back of my passenger seat metal bulkhead from my walkthrough early bay.
I've seen plenty of pictures of the conversion, but I've not found any details of the size of the plate required.
Does anybody have the dimensions of the plate?
Also, when cutting the bulkhead out, where is the best place to cut? Should I make the vertical cut along the B pillar from the passenger seat side or from the rear?
On the base section, Is the cut made above the lip of the seam of the two panels? If so, do you just hammer this seam flat & weld it onto the seat base for further strength?
Are the old seat runners easier to grind off or should I drill the spot welds?
Any recommendations on swivel seat bases?
All suggestions appreciated!