Recent content by Tatie2468

I can take these to Stanford Hall if anyone is interested for £35 cheers

£50 anyone?

hello PM me your email address and I will send you a picture cheers

I have 5 cards; 2 behind the front seats, 2 rear quarters and the big one opposite the sliding door. No sliding door card I'm afraid. They are the original grey vinyl ones from a 72 crossover bay in good condition £75 collected from Rotherham thanks

thanks for the responses

I'm considering buying a beam with built in beam adjusters from Transporterhaus my question is if I lower my van by approximately 2 inches on the front does it push the track out and if so by roughly how much? Transporterhaus are offering varying degrees of narrowed beam with the adjusters and...

i bought this with the intention of fitting it on a 1600 twin port engine I have but decided to stick with the single port engine I have. So the progressive carb is no longer required it hasn't had much use and includes the manifold £125 collected from rotherham Cheers

Tyre size is 195 65 15 which gives same rolling diameter as 185 r14c I think I need to check I'm getting full throttle Cheers

Once again thanks for the responses think I will first check the travel on the throttle cable and may ultimately invest in some twin carbs for the single port engine Cheers

I've had lots of beetles in my early driving years but my 72 crossover is my first type 2 and it seems to run out of steam very quickly it currently has a B code single port 1600 engine I was going to fit a twin port 1600 with a progressive carb and quiet pack exhaust to get a little more out of...

i need to lower the front of my crossover bay by about 50mm 2inches in old money to get it in my garage would beam adjusters offer the ability to lower by this amount and how does it affect the ride? Would I need to change my shocks? Thanks in advance

thanks for responses I shall take a look this weekend, I hate electrics cheers

as the title says I have a 72 crossover which has been stood for some time, the tank has been cleaned out but the gauge is reading full all the time any clues to what is could be would be helpful thanks

to get my standard ride height elevating roof camper (crossover 71 bay) into my garage I either have to raise the height of my garage door or lower my van by about 2.5 inches. I'm inclined towards the latter and would want to fit dropped spindles any advice on which are good and which are not so...

need the 2 red and 2 blue knobs for the heaters if anyone has any for sale Cheers