Recent content by owent2005

Early Bay Forum

Help Support Early Bay Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. O

    Front seat replacement options

    Afternoon all, I’ve finally decided to replace the original front two seats in my 71 plate van with something a little more modern. I’m after something that fits in with minimal fuss that gives a bit more support than the original! What seats do people go for? Is there a selection of standard...
  2. O

    Rear disc brake conversion

    Ok thanks Ozzie, do you know if the extra stopping power is worth the effort?
  3. O

    Rear disc brake conversion

    Hi, Is there such thing as a conversion kit to change from drums to discs on the rear and if so where can I get the kit? Thanks
  4. O

    Fuel Tank Contents

    Good morning, Has anyone got a reliable way of checking the fuel tank contents. My gauge has been dodgy in the past and the sensor was replaced so was hoping to keep an eye on it. Thanks
  5. O

    Positive or negative to auto choke?

    Hi, glad you got it running, the choke deffo connects to the positive connection from the coil. Ive never adjusted the choke before but here is a pretty good link. http://www.vw-resource.com/choke2.html Hope it helps, Owen
  6. O

    Fails to idle when hot [Solved]

    Good morning, I've now managed to get it to idle and it turned out to be the fuel filter. Thanks everyone for your help.
  7. O

    Fails to idle when hot [Solved]

    Evening all, so this afternoon I have changed the points, the rotor arm and dizzy cap. It still won't idle, after changing the rotor arm it idled for a minute or two then cut out. Is it possible there's a problem with it getting air, as I've changed/checked everything to do with the fuel and...
  8. O

    Fails to idle when hot [Solved]

    Ok, another update, I have now changed the carb and coil for known good ones and still no change. I can’t think of any other reason why it’ll run when I’m pressing the accelerator but not at idle. Any further thoughts would be welcome!
  9. O

    Fails to idle when hot [Solved]

    Ok thanks, I’ll try that when I get home.
  10. O

    Fails to idle when hot [Solved]

    Ok, thanks for the info I learn a little more each day! If the coil was the fault would it still be able to start and run for a while? it also ran continually with the oversized idle jet I put in?
  11. O

    Fails to idle when hot [Solved]

    Is the coil required to continually run the engine? I thought it was just to get it going?
  12. O

    Fails to idle when hot [Solved]

    Hi, Thanks for the thoughts guys, yep to check each item I swapped them out and still had the same problem, I haven’t checked under the points though. I have taken out the idle valve and cleaned it and this didn’t do anything although I swapped the valve for one with slightly larger holes. The...
  13. O

    Fails to idle when hot [Solved]

    After a warm afternoon working in the boot I have checked the following; condenser is fine, dizzy, cap and leads are all fine as are the spark plugs, the fuel pump is also ok. I’m baffled the only thing I did was swap the dizzy back and retime, now it won’t idle once warm. I’m thinking carb...
  14. O

    Fails to idle when hot [Solved]

    Evening all, I have recently refitted my 009 points dizzy after the electric ignition I installed failed. I took the bus for a drive and after about half an hour she started to cut out at low rpm, i.e. coming to a stop. She started again straight away and I just kept the revs up at low speeds...
  15. O

    Dizzy ID

    Hi, When I swapped my 009 dizzy with points ignition for an electric ignition SVDA dizzy, with the engine at TDC the new rotor pointed to the 2 o'clock. I rotated the spark plugs round on the dizzy cap and it works fine. Owen
Top