Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
EarlyBay Forums
Technical
Engine questions
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Early Bay Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="67panel" data-source="post: 628872" data-attributes="member: 13328"><p>Personally I would take the shims out as that compression is a bit low for that cam and to my mind will improve low end pull. As to the get into 4th over 30 mph my 1600 single port bottom end with ported twin port heads ,ITCs and header pulls like a train from 25 mph in 4th!</p></blockquote><p></p>
[QUOTE="67panel, post: 628872, member: 13328"] Personally I would take the shims out as that compression is a bit low for that cam and to my mind will improve low end pull. As to the get into 4th over 30 mph my 1600 single port bottom end with ported twin port heads ,ITCs and header pulls like a train from 25 mph in 4th! [/QUOTE]
Verification
Post reply
EarlyBay Forums
Technical
Engine questions
Top