Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
EarlyBay Forums
Technical
Engine questions
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Early Bay Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="montypsx" data-source="post: 628785" data-attributes="member: 16612"><p>If it is juddery low down the rev range but takes off when you floor it try putting larger emulsion tubes in the carbs it will give it more fuel and make it drive better I just had a similar problem with mine. Also did you break it in at 2000rpm for 30mins? </p><p></p><p>My build was 1641cc full flowed 100cam new crank bearings with ported heads I also matched all cylinders so they were the same cc and put 34icts on it with iridium plugs and Petronix distributor. After I put the new emulsion tubes in I’m getting an extra 6-8 mpg on normal roads and is sooooo smooth </p><p></p><p>Hope this helps</p></blockquote><p></p>
[QUOTE="montypsx, post: 628785, member: 16612"] If it is juddery low down the rev range but takes off when you floor it try putting larger emulsion tubes in the carbs it will give it more fuel and make it drive better I just had a similar problem with mine. Also did you break it in at 2000rpm for 30mins? My build was 1641cc full flowed 100cam new crank bearings with ported heads I also matched all cylinders so they were the same cc and put 34icts on it with iridium plugs and Petronix distributor. After I put the new emulsion tubes in I’m getting an extra 6-8 mpg on normal roads and is sooooo smooth Hope this helps [/QUOTE]
Verification
Post reply
EarlyBay Forums
Technical
Engine questions
Top