Search results

The volts will drop to 10 on cold crank giving you a week spark, best thing is to fit a ballasted coil. using a relay fed by the starter crank feed you will get a good voltage at the coil. It will be a 10v coil with the voltage dropped by the ballast , when ballast is bypassed you should still...

Have a look at my bus build Spliffy the panel , home brew Polo rack and 90deg Renault Master box.

boot polish dear

we are not tight Oz just economical, my old ones went back on.

Not a drive shaft joint?

Brown on ign switch is for key buzzer I think, you are correct on the dip switch wiring just check the earth on back of instrument cluster.

Well the fuel gauge is wired with an ign feed then the other side goes to tank unit that should have an earth (brown) wire to ground. Sounds to me like the ign feed is interrupted when the lights are turned on? Check the light circuit and the fuel gauge is wired correctly.

I have never had a problem with bolt on covers, use cork gaskets . I also use clear Bostic on the gaskets to glue them to the covers. Well it works for me.

Does that mean the s/h unit I have is worth dosh?

I fitted the early brake kit to my late drop spindles, needs an adaptor machining and the original calliper mountings removing. How to in Spliffy the panel build in gallery.

Just check the voltage (engine off) at the large terminal (battery +) on the alternator just to see if you have continuity. I drove all the way across Sweden and from the ferry to Malvern in my Dodge on the same fully charged battery from start. It was flat as the next morning!! The alternator...

Bugger its the same weekend as the Upton Blues festival, cant miss that as its in staggering distance of my flat (tipsy, who me ?)

If you have met Oz then you know he usually ends up under a seat-----------

Yes thats it just down the inside of chassis rail with grommeted holes at each end. Cant get to take pics at the moment unless there is one on the build thread in Gallery under Spliffy.

No tube on my 68 (67 build) just grommets as on all the bays I have seen, sounds like someone's add on?

Yup double nut it and I dont mean a Barnsley hand shake! It might be hard to line up on reassemble though.

Yes, just get some help to hold it. At least a 2 person job and 3 is better.

I prefer stone chip,

Now I refrained from that but it did spring to mind!!! or was that the picture of the Madonna with the big bobbies?

Its all about the resistance