6” fuch fitment
- Thread starter Bobreoc
- Start date
Help Support Early Bay Forum:
Heebee_GB
Well-known member
http://transporterhaus.de/index.php/product/porsche-130-pcd-rear-hub/
Would these work?
Would these work?
radish
Well-known member
With a 71 you can redrill your hubs and drums to 5x130pcd and they should fit. Find a machinist with a pillar drill with turntable and they should do it for less than £50
Hub caps won't fit though but a machinist can trim 20-25mm off the snout of the drive shafts and then the will.
Fuchs are ET45 I think same as comics which I run. I use to run 6" teledials which are ET52.3
Cheers Darius
Hub caps won't fit though but a machinist can trim 20-25mm off the snout of the drive shafts and then the will.
Fuchs are ET45 I think same as comics which I run. I use to run 6" teledials which are ET52.3
Cheers Darius
mychatype3
Well-known member
I run old Fuchs (6J Et36) the work only if you convert 5x112 hubs to 5x130 as Darius stated
