Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
EarlyBay Forums
Technical
Problem removing CV shafts
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Early Bay Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="slow-lane-Matt" data-source="post: 588453" data-attributes="member: 19329"><p>I replaced boots on left side of bus a few years back - no problems.</p><p></p><p>Now doing the right side. I can undo the bolts on wheel side no problem with M8 splined tool, but can't </p><p>get the tool to bite any of the inner gearbox side bolts. </p><p></p><p>I've cleaned with WD40 and brushed so don't think it's grit.</p><p></p><p>The tool almost fits, so I think the next size down would be too small, and would seem unlikely</p><p>to have different sized bolts on inner and outer...</p><p></p><p>Has anyone ever seen M6 spline bolts on a bus...</p><p></p><p>Do the bolts deform after a while...?</p><p></p><p>I'm reluctant to hammer the spline tool in.</p><p></p><p>I tried mole grips around the outside - but bolts too tight to budge</p><p></p><p>Am I missing something....?</p><p></p><p>Thanks </p><p></p><p>Matt</p></blockquote><p></p>
[QUOTE="slow-lane-Matt, post: 588453, member: 19329"] I replaced boots on left side of bus a few years back - no problems. Now doing the right side. I can undo the bolts on wheel side no problem with M8 splined tool, but can't get the tool to bite any of the inner gearbox side bolts. I've cleaned with WD40 and brushed so don't think it's grit. The tool almost fits, so I think the next size down would be too small, and would seem unlikely to have different sized bolts on inner and outer... Has anyone ever seen M6 spline bolts on a bus... Do the bolts deform after a while...? I'm reluctant to hammer the spline tool in. I tried mole grips around the outside - but bolts too tight to budge Am I missing something....? Thanks Matt [/QUOTE]
Verification
Post reply
EarlyBay Forums
Technical
Problem removing CV shafts
Top