Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
EarlyBay Forums
Technical
Hex Bar Linkage
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Early Bay Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="mike202" data-source="post: 634185" data-attributes="member: 17202"><p>Just as a matter of interest for you, I have the CSP bell crank linkage and had similar problems with the engine racing at junctions etc. I found out that the linkage is not supplied with a spring. The buttys bits throttle spring and the carb springs ( very small Weber 34 ICT) wasn’t enough to return the carbs to idle when the engine was warmed up. I got a CSP spring made for the linkage which goes inside the bell crank part, and this cured all problems.</p></blockquote><p></p>
[QUOTE="mike202, post: 634185, member: 17202"] Just as a matter of interest for you, I have the CSP bell crank linkage and had similar problems with the engine racing at junctions etc. I found out that the linkage is not supplied with a spring. The buttys bits throttle spring and the carb springs ( very small Weber 34 ICT) wasn’t enough to return the carbs to idle when the engine was warmed up. I got a CSP spring made for the linkage which goes inside the bell crank part, and this cured all problems. [/QUOTE]
Verification
Post reply
EarlyBay Forums
Technical
Hex Bar Linkage
Top