Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
EarlyBay Forums
Technical
Crank trigger ignition - info and ramblings!
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Early Bay Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="dubdubz" data-source="post: 624726" data-attributes="member: 1072"><p>Ah</p><p>Thanks Jon. That makes more sense - the issue was I am using VTR throttle bodies so the ‘wrong’ end had nothing protruding to even put something on, it goes into a blind bearing cap and does not extend out... I did find the throttle plate screws for a £ each but lost the url, and as I clear out my history weekly I’ll have to refund</p><p>M4 x 0.5 thread pitch and minimum of 7mm long but I’d be ok cutting down as I want to swage them like the originals...</p><p></p><p>https://www.ebay.co.uk/itm/123130143972</p><p></p><p>If you look at the left hand set of tbs you’ll see the shaft doesn’t come through</p><p></p><p>And yes it’s a bit of work, but I got 2 complete sets for about £40 I think posted, so if I do sack this as a bad job it’s not big money wasted. Plus they come with injectors! So if it works out it’s quite a saving...</p></blockquote><p></p>
[QUOTE="dubdubz, post: 624726, member: 1072"] Ah Thanks Jon. That makes more sense - the issue was I am using VTR throttle bodies so the ‘wrong’ end had nothing protruding to even put something on, it goes into a blind bearing cap and does not extend out... I did find the throttle plate screws for a £ each but lost the url, and as I clear out my history weekly I’ll have to refund M4 x 0.5 thread pitch and minimum of 7mm long but I’d be ok cutting down as I want to swage them like the originals... https://www.ebay.co.uk/itm/123130143972 If you look at the left hand set of tbs you’ll see the shaft doesn’t come through And yes it’s a bit of work, but I got 2 complete sets for about £40 I think posted, so if I do sack this as a bad job it’s not big money wasted. Plus they come with injectors! So if it works out it’s quite a saving... [/QUOTE]
Verification
Post reply
EarlyBay Forums
Technical
Crank trigger ignition - info and ramblings!
Top