Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
EarlyBay Forums
Technical
Crank pulley keeps coming loose
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Early Bay Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="ozziedog" data-source="post: 598141" data-attributes="member: 13810"><p>Is it possible that when you torque it up, that it is just tightening itself and not the pulley? Torque him up and put a vertical permanent marker line on vertically. Then take the pulley off and torque it again without the pulley, is it in a the same place ? Or measure it or put a large washer or two on it to make it tighten on the pulley. Reckon it might be torqued but not tight on the pulley.</p><p></p><p>Ozziedog,,,,, ,, lets hope its an easy one. :mrgreen:</p></blockquote><p></p>
[QUOTE="ozziedog, post: 598141, member: 13810"] Is it possible that when you torque it up, that it is just tightening itself and not the pulley? Torque him up and put a vertical permanent marker line on vertically. Then take the pulley off and torque it again without the pulley, is it in a the same place ? Or measure it or put a large washer or two on it to make it tighten on the pulley. Reckon it might be torqued but not tight on the pulley. Ozziedog,,,,, ,, lets hope its an easy one. :mrgreen: [/QUOTE]
Verification
Post reply
EarlyBay Forums
Technical
Crank pulley keeps coming loose
Top