Search results

Have seen a few people 3D print a few bits and bobs on here...has anybody looked into printing the speedo needles? Just bought an MPH speedo for my Swedish bus, but the needle didn't survive the journey to me :( Cheers.

Oops. One of the six studs holding the oil strainer plate has come out with two of the threads of the case and now will obviously not tighten fully. Is there a quick fix for now? Guessing helicoil is the only long term solution...just wonder if anybody else has had this. Ta!

As title says, looking for a pair of these. Cheers :)

As above....do you have any knocking about in a dusty corner or propping a door open? Might be interested. Cheers.

Hi. Could anybody advise me of the correct way to fit the balance pipe in a SP 1600 running duel Weber 34 ICT carbs please? Bus is running a brake servo. Thanks :)

Hi. At some point this year I want to go to a disc brake setup on my early bay. What do I need to keep my eyes out for parts wise to do this on wide 5 wheels? On a budget, so can't be buying expensive kits etc. Any advise gratefully received. :)

Been looking for some secondhand dropped spindles, but think the flipped 3.5 ones are going to drop the old girl too far on top of the cut and turned beam. So if anybody knows of one of these kits going cheap I could be interested. Thanks. :)

Saving towards one, but just incase anyone has one surplus to requirements I'm in the market for one. :)

Hi. Picking up a '70 bay next week after a 15 year break. :D Can anybody please advise me on the best steering lock? I also want to fit a fire extinguisher in the engine bay if anyone has any views. Thanks Ryan

My eternal hunt for the right Split project continues but in the meantime I need to replace my daily before its inevitable MOT failure early next year. Early 68-70 walk-through tintop bay is preferred, has to be a runner or as close to it as poss, no time to do loads of work for MOT. 8k-ish...

Hi I'm looking for a keenly priced, dry early bay that I have a chance of getting on the road in the next couple of months, must be a walkthrough tintop, 68-71 flat front arch and half moon rear vents. Cheers :D

Hi all. After a long search I may of found the bay for my family. Solid Rhd with pop, just one dodgy jacking point. Happy with how solid it is, but a couple of issues that I am unsure of, like how serious they could be. It drives straight until braking, then it pulls slightly to the right. The...