Search results

Know this is a bit of an old thread, but I need new lamps in my70. Can I ask how you mounted the sealed units in? I currently only have the one tab to take the stock 3 screw lights.

Spent the morning in the shed and made one, very pleased with it! Can hardly tell it's not original. :D

I would if there was anything left to glue! Currently rocking piece of bamboo kebab stick :shock:

Have seen a few people 3D print a few bits and bobs on here...has anybody looked into printing the speedo needles? Just bought an MPH speedo for my Swedish bus, but the needle didn't survive the journey to me :( Cheers.

Thanks. Waiting for the studs to turn up in the post!

Oops. One of the six studs holding the oil strainer plate has come out with two of the threads of the case and now will obviously not tighten fully. Is there a quick fix for now? Guessing helicoil is the only long term solution...just wonder if anybody else has had this. Ta!

As title says, looking for a pair of these. Cheers :)

If sale on rear plates falls through, give me a shout.

As above....do you have any knocking about in a dusty corner or propping a door open? Might be interested. Cheers.

Hi. Could anybody advise me of the correct way to fit the balance pipe in a SP 1600 running duel Weber 34 ICT carbs please? Bus is running a brake servo. Thanks :)

No worries...also I clearly cannot read as it was in the title. Boy I'm tired! :oops:

Hiya. Is this a complete set of four over riders? Cheers Ryan

How much you looking for? I've only just started looking into this so not sure what route to go yet...

Thanks. I'm in no rush as I've just rebuilt the drums to get me through this summer, just wondered if there is a shopping list of bits I need to acquire, or if the is a thread someone knows of that I can take a look at...

Hi. At some point this year I want to go to a disc brake setup on my early bay. What do I need to keep my eyes out for parts wise to do this on wide 5 wheels? On a budget, so can't be buying expensive kits etc. Any advise gratefully received. :)

Thanks for the suggestion and will keep an eye out, but was looking for second hand parts for short term use. Want to fit a complete Red 9 DW setup when funds allow so buying new at the moment is a no no. :)

Been looking for some secondhand dropped spindles, but think the flipped 3.5 ones are going to drop the old girl too far on top of the cut and turned beam. So if anybody knows of one of these kits going cheap I could be interested. Thanks. :)

Obviously Rusty has first dibs on any, but just incase another set pops up I would be interested. :)

Saving towards one, but just incase anyone has one surplus to requirements I'm in the market for one. :)

Slightly inconvenient for the school run ;)