Recent content by Pellwood

Hello from Bristol, still working full time. I have worked from home for the past 5 years but now have a wife and three kids for company (which is not as fun as it sounds believe me). Anyway I should count my blessings as I've been largely unaffected by what is going on and its given me an...

Plus 1 for the Butty's Bits throttle linkage. Fitted it and never looked back.

Really interested in the cooker, PM’d you (I think) I can collect this week (apart from Friday) Regards Pete

Lol nice one, that’s what I did, good to see the interiors being reused. Sent from my iPhone using Tapatalk

Here is an article which goes in to some more detail and defines the process for applying for MOT exemption. You may have seen it already. So apologies if I’m reposting old stuff. The article also has details of what would constitute a change to a vehicle that would negate its MOT exemption. It...

Just out of interest my tin looks similar to yours and it’s actually my pulley tin that covers that gap. Although I can’t say where my tin has come from but I’m in the process of replacing it piece by piece with as much original tin as I can. This is my pulley tin And this is my front tin...

Did you get anywhere with this? Ive got a Devon swing out cooker so could measure it up and provide dimensions if you still need them?

True, this site logs all entries in its database and won't allow duplicates, however, it will let you view the database entry which has all the details decoded from the original submission.

You could try http://www.vw-mplate.com/mcode.php

Thanks for the advice re the tank & breathers, I will check. I had covered some of the other tests already. I should have mentioned before but to give you some background. I have completed a top end rebuild and replaced the coil, plugs and leads, plug gaps set. Valve gaps set ok, electronic...

So we got caught in the tail backs on M5 over the weekend. We had been cruising up the Mway around 55mph for an hour or so then hit very slow moving traffic, we drove in a stop start fashion for around 2 hrs and then the engine got more spluttry then died and would restart. We got to the hard...

Hi guys, Which thread locker do you apply when torquing the gland nut? There seems to be a bewildering array of numbers. Loctite 272 seems to be the strongest I can find. Any ideas?

Thanks for the responses, they were bought as part of a top end rebuild kit from Machine 7, i will try to swap the pins around as well to get them as close to each other. At the moment im just after a stock setup. Maybe i will put a thread up when i start the rebuild. At the moment i have just...

I am doing a top end rebuild and was wondering about the tolerances for piston weights. I have a set of Mahle cast pistons including pins & rings with 3 that weigh 504 grams and one that weighs 498 grams. Is the difference between them acceptable or should I machine the other 3 down to the...

Excellent article Sparky, I have always gone by driving up to 10mph in first, up to 20 in second, 30 third etc. So it looks like I've been doing something half right after all. However, I'm not sure about the following sentence from the article: "When an particular traffic situation makes it...