Hi Mike,
I renewed my split charging setup not too long ago.
Not a difficult job to tackle if you haven't already talked yourself out of it.
Take a look at the below kit as a starting point, with ready terminated connectors, and a relay which I can highly recommend...
Shame about that.
Previous owners all seemed happy to hear from me.
I understand why they are reluctant to share information, but I think most of us on here would be happy for new owners to get in contact.
I applied for the history of 20 previous owners in 2016.
Took a good few weeks but only cost £5. About an inch thick pack came through with all old v5s etc. Best fiver I have spent on the van!
As an update to this, measured up again with a mate...
Wheels are actually 15x5.5 (wasnt measuring between beads)
And offset looks like ET25 (although may be slightly different)
Centrebore measuring 66.6mm
One bump before eBay
I have gone back to steels on my panel van.
Up for grabs are a set of BRM 15s.
I think they are 15x6J et35 - but my measurements could be wrong, and nothing stamped on rear of rim.
They have some pretty harsh corrosion to the polished areas as pictured, definitely in need of a refurb...
Couldn't find anything this side of the pond...
An alternative for anyone else looking.
http://www.brick-yard.co.uk/forum/home-made-vw-centre-caps-for-merc-steels_topic84547.html
Anybody know of anything similar to this here in the UK.
http://www.van-cafe.com/mefro-center-cap-p1580
I'm looking for something to tidy up the centre of a steel on a crossover running mercedes steels...
Yes mate RHD offside part is the worst one.
I definitely have the early steering box, so if that's the case, suppose i will have to wait for the correct one